How to connect EV_T5837-FX2 with some host MCU?

[APDahlen]

Hello @sr007,

Recommend you solder 30 AWG wire to the board’s pads (e.g., G, V, D, etc).

You can then wire wrap the other end to a 0.1 header. The classic solution is the Jonard Tools WSU-30M and a spool of 30 AWG wire. Your microcontroller development board likely equipped with the 0.1 inch headers.

Happy twisting,

APDahlen

Use Wire Wrap Techniques for Secure Wire to PCB Connections

What is wire wrap? The wire wrap technique and tools facilitate semipermanent electrical connections for low current applications. As shown in Figure 1, small gauge wire is wrapped around square posts such as the 0.1 in pitch headers attached to this used Arduino PORTENTA Pro breakout board. The result is a fast heat- and chemical-free joint with good mechanical stability on par with a soldered joint. The square pin is an important stipulation for the wire wrap technique as it ensures a solid o…