# Identifying crimper / tooling for TE CPC Series 4 connectors

**URL:** <https://forum.digikey.com/t/identifying-crimper-tooling-for-te-cpc-series-4-connectors/44946>\
**Category:** Tools\
**Tags:** crimpers-applicators-presses, te-application-tooling, part-identification\
**Created:** [September 16, 2024, 9:28pm UTC](https://forum.digikey.com/t/identifying-crimper-tooling-for-te-cpc-series-4-connectors/44946 "2024-09-16T21:28:16Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![garyr1](https://avatars.discourse-cdn.com/v4/letter/g/43a26b/32.png) [@garyr1](https://forum.digikey.com/u/garyr1)\
**Post date:** [September 16, 2024, 9:28pm UTC](https://forum.digikey.com/t/identifying-crimper-tooling-for-te-cpc-series-4-connectors/44946/1 "2024-09-16T21:28:16Z")

</div>

Looking for recommendations for a hand crimpers or a single crimper w/ multiple die sets to support TE’s CPC series 4 connectors.  
Application is connector 207485-1, with multimate type lll+ contacts 66565-4 and type Xll contacts 66740-6. TE calls out two different crimpers. Is there a common hand crimper that can serve both contacts, or recommended third-party crimper(s)?

---

<div class="post-metadata">

**Author:** ![nick\_13812](https://avatars.discourse-cdn.com/v4/letter/n/ecb155/32.png) [@nick\_13812](https://forum.digikey.com/u/nick_13812)\
**Post date:** [September 16, 2024, 9:58pm UTC](https://forum.digikey.com/t/identifying-crimper-tooling-for-te-cpc-series-4-connectors/44946/2 "2024-09-16T21:58:33Z")

</div>

Hello garyr1 and welcome to the DigiKey TechForum.

I did find [2063487-1](https://www.digikey.com/en/products/detail/te-application-tooling/2063487-1/16634470), that does have its series listed as Multimate III+ and XIII that may work for you depending on the gauge wire you are using.

---

<div class="post-metadata">

**Author:** ![garyr1](https://avatars.discourse-cdn.com/v4/letter/g/43a26b/32.png) [@garyr1](https://forum.digikey.com/u/garyr1)\
**Post date:** [September 17, 2024, 1:52pm UTC](https://forum.digikey.com/t/identifying-crimper-tooling-for-te-cpc-series-4-connectors/44946/3 "2024-09-17T13:52:42Z")

</div>

Thank you. I had not seen this particular crimper searching through TE’s website. I will investigate further and confirm.