STM32mp157c

Hello everyone,

I’m new to STM32 and I’ve followed all the steps outlined in the “Getting Started” page on this link: Debian Getting Started with the Odyssey STM32MP157C.

However, after inserting the SD card, I didn’t see any reaction. If anyone could help, I would greatly appreciate it.

Also, I have a question: Can I directly download the image and flash the board using the Etcher application?

Thank you.

Hi @yass.bouazz.23

Do you have usb-serial adapter hooked up to pins 6 (gnd), 8 (tx) and 10 (rx)? So we can see what the bootloader is doing?

image

Regards,