Microsemi FLASHPRO5 Installation Trouble Shooting

[PaulHutch]

This 2018 post might help (last post in the thread linked in the OP).

No Serial Port Created by Maker Board

Thank you for your answer, it was enough for the solution. When i right click and open the properties of the USB FP5 Serial Converter A there was an option “Load VCP” in the advanced tab. This option was checked only for Converter C. When i checked it for all of them and unplug - reinserted the device, all ports were under Ports (COM & LPT) The FlashPro5 port that i already seen was the UART port. The baud rate however shown as 9600 not 115200. You need to change it to 115200 to communicate…