Question:
What are soldering methods and conditions for a basic switch?
Answer:
In addition to the basic soldering method of basic switches (see Explanation), note the following:
- Soldering operation should be performed at or below the temperature and time specified in the specifications, and external force should not be applied for 1 minute after soldering.
- Pay attention to the insulation distance after soldering.
- When soldering to PWB, apply flux inhibitor (such as Surflon) to the switch mounting surface before use.
- Do not clean open type switches after soldering.
Explanation:
The basic soldering method of basic switches is shown below.
Product category
Switches Basic Switches
Classification
Mounting, Storage
Related keywords
Basic Switch
Soldering Method
Flux Inhibitor
Twist Lead Wires
Short Circuit Failure
Solder Ball
Solder Waste
Soldering Temperature
Please visit the link below to see this product category on the Digi-Key website
Switches | DigiKey Electronics
This FAQ has been brought to you courtesy of
Please click the link below to view the original FAQ