Hi all,
I broke a solder connector for a Roland Juno 106. They appear to be riveted in. I intend on replace all five it with something as close to the original as possible. Open to recommendations for alternative parts. I am considering replacing whole board, but that is pricey at the moment. (see pictures)
Thank you!
Hi @mattjnormand and welcome to the TechForum!
If the rivet is still intact and secured to the board, you may be able to solder a wire connection directly to it without replacing the entire terminal. What’s stopping you from doing that?
These parts might be worth exploring too.
Rivets and Solder Lug connectors
Review this article I found showing this kind of application linked HERE.
Best regards!
Cool thank you.
There’s the same break near the one photographed. I am certain this may happen again when i reassmble everything. It looks kind of terrible.